44755_primo_260510_0113-tilrettet-scaled

Husk også...

T2000643 – Clips for FiberCore Side/Top Glass Strip

T2000628 – Clips and screws for FiberCore side/top glass trim

4199, 2.5 m – FiberCore Side/Top Glass Trim, White

PRIMO FiberCore glazing beads are an energy-efficient and durable solution for both windows and doors.
They are made from an advanced composite that combines natural plant fibers with the strength and low-maintenance properties of plastic.
This means that the glazing beads insulate up to 160 times better than aluminum and have a U-value of just 0.18—which effectively reduces heat loss around windows and doors.
At the same time, the material is resistant to moisture and weather. It does not absorb water and will not rot, crack, or dry out. This provides a solution that requires minimal maintenance and extends the lifespan of the windows.

Do not crack

Easy to mount

Flexibel

Shape as you like

No need to paint

Minimal maintenance

Dette produkt har ingen varianter

Additional information

Varenummer
DB
EAN
Højde
Bredde	17 mm
Længde	2.500 mm
Colli
Produkttype
Toldnummer	39162000

PRIMO FiberCore side window trim is installed using the same smart clip system as the bottom trim. This ensures a neat, hidden installation and a durable solution without visible nail holes. Follow the steps below for proper and safe installation:

Remove one trim at a time
. Carefully loosen and remove the old side window trim—one at a time—and install the clips immediately to ensure the window does not fall out.
– Place the clips against the glass
. – Secure them in pre-drilled holes with screws driven at an angle into the rebate.
Select the finish type (A or B)—download the instructions below.
The side glass strips can be finished in two ways:
A: Against a continuous top glass strip with a 16° bevel at both ends
B: With a 45° bevel at the top and a 16° bevel at the bottom
Since FiberCore does not absorb water, the strips can be installed directly down to the bottom glass strip.
Prepare for cutting and
check – Clips must be installed on the side and top glass strips before cutting to ensure a proper miter –
Use 5 clips per
meter – The distance from corners must not exceed 5 cm
. After cutting to length, place the strips in the groove to check the fit – without snapping them into place.
Important: Once the strips are installed, they are difficult to remove.
Snap the strip into place
. Press the glass strip toward the clip with light pressure until the snap-in mechanism engages. The glass tape can be moistened with soapy water to make installation easier.